The Jolly Cue Ferrule Sander is a device that accurately flattens down the
top of the ferrule and the bottom of the tip needed for gluing a new tip on your
pool cue. This 2 in 1 tip tool will give you a perfect level on each end with a
little bit of a rough texture to assure proper installation. This tool makes it
easy to replace tips right on the spot and is easy to use, capable of flattening down up 8 tips at one time 2 for each diameter ranging from 11 to 14mm. For flattening down ferrules it features an adjustable knob to fit an 11, 12, 13 or a 14mm shaft. Includes a carrying bag, 1 extra disk sander and instructions.
Overall Rating for Jolly Cue Ferrule Sander
 | (based on 4 reviews) |  |
jolly cue sander
By Herb from Penna. on February 2, 2012
Sands and flattens fast , it leaves deep sanding grooves on ferrule. Should have a finer grit paper.
I would recommend this item to a friend.
jolly cue ferrule sander
By joselito from , on September 19, 2011
very effective
I would recommend this item to a friend.
jolly cue sander best so far...
By jason from hayward, CA on August 26, 2011
I have previously been using the tweeter tip kit, and got my Jolly Cue tool and wouldnt use anything else, as close to using a lathe that u can get, and the part that holds the tips with specific sized holder is much needed also.....
I would recommend this item to a friend.
jolly ferrule sander
By rickey abdullah from mount vernon TX. on August 14, 2011
jolly sander works very well I put tips on for extra money . this tool takes a lot of work off you dont over tighten tool to shaft easy to ding shaft take it slow when sanding ferrule as sanding disc is very aggressive it sands ferrule and tip level worth the money
I would recommend this item to a friend.
